Accurately notches tubes and pipe from 0- 50º with the additional ability to offset the notch +/- 25mm from the centre line.

Solid steel construction with needle roller bearing to ensure smooth operation
Clamp in a vice or bolt to a table and use with any hand held drill
Notch pipes and tubes with an OD from 19mm to 76.2mm (3/4-3")

• Features
• The cutter centreline is height adjustable to accommodate a wide variety of workpieces
• Adjust cutting angle up to 50º
• Works with a 12mm chuck Power Drill
• Accepts hole saw thread sizes: 1/2” x 20tpi, 5/8” x 18tpi
• 25mm steel shaft